Enabler 4P
BJ-240
Control blinds, screens, curtains or other motorized elements
Enabler 4P Motor is a device with 4 pairs of switched relay contacts that allows you to control two different functions (normally raise and lower) of 4 motorized elements, such as blinds, curtains, screens, kitchen furniture, etc. The up & down and open & close functions of these elements can be activated using our remote controls or by means of a switch.
This device requires Enabler Core to work.
This device is part of our environmental control solution.
Suitable for
- Physical disabilities: spinal cord injuries, multiple sclerosis, ALS, neuromuscular disorders...
- Cerebral palsy
- Brain injuries: ictus, traumatic brain injury...
- Supply voltage: 5VDC
- Power suply: 230VAC
- Controllable with our remotes.
- Size: 109 x 59 x 36 mm.
- Radio Frequency: 433 MHz.
- 4x2 switch inputs for direct manual control.
- Three operating modes selected with a jummper: latched (auto-off at 55 seconds), dead man and combined.
- In the combined mode, the operation depends on the length of the click:
- Short click: latched (auto-off at 55 seconds).
- Long click: dead man.
- Compatible only with 230VAC single phase engines.
- Direct connection to the engine without additional wiring.
- Maximum load: 1000W (5.5 A / cos = 0.8).
- RS-232 port to connect to Enabler Core
This project has received funding from the European Union’s Horizon 2020 research and innovation programme under grant agreement No 827220